![]() Align the tongue (the shorter leg) of the carpenter's square with the centerline of the axle. ![]() If not using raked trees or raked cups you can simplify this and use the centerline of the rigid leg of the springer. Rule 1: place the blade (the long end) of a carpenter's square along the centerline of the steering axis. that in turn will tell you where to place your spring leg attachment hole. This rule dictates the position of the rear(rigid leg) rocker attachment hole. ![]() 75" for riders 200# or more i go a full 1". I set the front of the frame.75 to 1" above the final position of the weighted frame(containing motor trans and rider). I block the front of bike frame with 2x4 and shimming stock. First and foremost do not have any weight on the frontend. The 90* angle rule: this rule was set up to dictate the proper measuring and assembly of the springer rockers. We have been working on and refining the rule and i will put out the inital writing and hope others can review comment and help make a solid design principle. So i have written down that i believe to be the rule for setting up a springer rocker mounting system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |